How to Apply Cut Vinyl (HTV / Flex) onto Football Shirts (Heat Press & Household Iron)
đĄïž Quick Reference Guide
| Pressing Method | Temperature (°C) | Press Time | Carrier Peel | Pressure Level |
| Professional Heat Press | 140°C â 145°C | 10 â 12 seconds | Hot / Warm Peel (Film dependent) | Medium (3â4 bar) |
| Household Iron | ~140°C (Polyester/2 Dots) | 15 seconds | Warm / Cold Peel | Heavy (Firm body weight) |
đ Method 1: Professional Heat Press
-
Set Machine Parameters: Set heat press to 140°C â 145°C with Medium pressure.
-
Pre-press Jersey: Press shirt for 3 seconds with a Teflon sheet to remove moisture.
-
Position HTV: Lay cut flex vinyl design with sticky carrier side onto the shirt.
-
Step 1 â Press: Cover with Teflon sheet and press for 10â12 seconds.
-
Step 2 â Carrier Peel: Peel plastic carrier backing off (Hot or Warm according to specific HTV brand instructions).
-
Step 3 â Post Seal: Cover bare HTV with Teflon sheet and press for 2â3 seconds to seal edges.
đ Method 2: Household Iron
-
Iron & Surface Prep: Set iron to Polyester / Synthetic (~140°C). Steam OFF. Work on hard surface.
-
Pre-iron Area: Iron target area for 3 seconds.
-
Position & Cover: Place vinyl and cover with parchment paper.
-
Step 1 â Press: Press vertically straight down with firm body weight for 15 seconds.
-
Step 2 â Peel: Wait 30 seconds (warm peel), then gently pull carrier off.
-
Step 3 â Edge Lock: Cover design with parchment paper and press for 3 seconds.
đĄ Pro Tip: Standard Cut HTV is very thin and flexible. Keep press time short (10â12s) to avoid heat lines on football shirt fabric.
